1.Cambox mounting height 125mm (from the center of camshaft to bench mounting platform) 2.A speed sensor installed on the cam box for injection synchronization 3.Modulated driving signal to ensure the safety of EUI/EUP solenoid 4.User adjustable s... - Update: 2008-09-12

1.The CRS-2000 meets the synchronization requirement to drive an ECD-U2 pump and 6 injectors. 2.Pump operation - Close-loop control of rail pressure to reach the required rail - pressure - Manually adjust pump load 3.Injection operation ... - Update: 2008-09-12

1.Two user selectable operational control modes a)- Open-loop control mode The angular position of the rotary-magnet actuator is controlled by manually setting the duty circle of the driving PWM signal. b)- Close-loop control mode The operator se... - Update: 2008-09-12

Frequency response up to 20KHz, capable of monitoring the dynamic characteristics of drive current for electromagnetic valves on electronic diesel engines Two levels of output gains, 100mV/1A and 10 mV/1A Maximum measured current 60 A Zero adju... - Update: 2008-09-12

1.Modulated driving signal to ensure the safety of the solenoids of the injectors 2.Injector driving signal - Adjustable frequency and pulse width 3.Short circuit protection for solenoid driving signals 4.Rich accessories, ready to test Bosch, Den... - Update: 2008-09-12

1.Combine two independent modules for pump and injector control 2.Pump driving signal - Adjustable duty cycle?while monitoring 3.fuel rail pressure 4.Injector driving signal - Adjustable frequency and pulse width 5.Modulated driving signal to ... - Update: 2008-09-12